부산대학교 도서관

When finger joints become immobile due to an accident during sports or a widespread disease such as rheumatoid arthritis, customised finger joint implants are to be created. In an automated process chain, implants will be produced from ceramic or metallic materials. Artificial intelligence-supported software is used to calculate three-dimensional models of the finger bones from two-dimensional X-ray images. Then, the individual implant design is derived from the finger model and 3D printed. The 3D printing process and the structures used are evaluated via model tests and the final implant design via a reliability calculation in a way to ensure that this is also possible via an AI process in the future. Using additive manufacturing with silicon nitride-based ceramics, model specimens and implants are produced via the lithography-based ceramic vat photopolymerisation process with full geometry or elements of triple periodic minimal surfaces structure. The model specimens are tested experimentally, and the loads are matched with a characteristic strength assuming a Weibull distribution of defects in the volume to generate and match failure probabilities. Calculated fracture forces of the silicon nitride-based ceramic structure was validated by comparison of simulation and tests, and the calculation can be used as a quality index for training of artificial intelligence in the future. The proposed method for individualized finger implant design and manufacturing may allow for correction of potential malpositions of the fingers in the future.