부산대학교 도서관

Highlights Three‐dimensional multi‐axial warp knitted (3D MWK) reinforced composites are important components of advanced structural composites. The interfacial bonding between fiber and matrix is key to achieving high mechanical properties. In this work, graphene oxide (GO) and poly(oxypropylene) diamines (D400) were grafted on glass fiber (GF) multi‐axial warp knitted (MWK) fabrics to construct a “flexible‐rigid” structure. The surface morphologies of GF were characterized by SEM and EDS. Then, 3D MWK‐reinforced composites were prepared based on four kinds of modified fabrics using the VARTM method. The in‐plane compression properties were obtained at different high temperatures and their failure modes were analyzed. The strain–stress curves showed that the composites exhibited brittle fracture modes. D400 and GO‐modified multi‐scale composites exhibited outstanding compression properties. The strength of the related composited was improved by 55.78%, 76.78%, 52.19%, and 56.78% compared to that of desized composite at 30°C, 60°C, 120°C and 150°C, respectively. The damage to D400‐GO modified and D400 modified composites was the most serious, where shear fracture modes were obvious in addition to layer debonding features. This protocol provides a potential strategy to manufacture of D400 and GO‐modified hierarchical reinforced composites. The modified 3D MWK glass fabrics based on poly(oxypropylene) diamines (D400) and graphene oxide (GO) were prepared. The compressive properties of 3D desized, D400‐, D400‐GO‐, and GO‐MWK fabrics reinforced epoxy composites were obtained and analyzed at different temperatures of 30°C, 60°C, 120°C, and 150°C. The failure mechanisms of 3D desized, D400‐, D400‐GO‐, and GO‐MWK fabrics reinforced epoxy composites at different temperatures were analyzed. [ABSTRACT FROM AUTHOR]