부산대학교 도서관

Recent advances in electronics and microfluidics have enabled several research groups to develop fully integrated, sample-to-result isothermal nucleic acid amplification test (NAAT) platforms for the point of care. However, high component counts and costs have limited translation of these platforms beyond the clinic to low-resource settings—including homes. Many NAATs include complex, multi-component heater electronics based on flex circuits or multiple printed circuit boards (PCBs) to support essential NAAT steps such as lysis, sample deactivation, and nucleic acid amplification. In contrast, current commercial assays for home use, such as those for pregnancy or ovulation that include electronics, typically have just one onboard PCB. This work describes a generalizable strategy to integrate all heaters and the electronics needed to control them onto a single low-cost, USB-powered PCB. We built a multiplexable disposable NAAT ("MD NAAT") platform that applies these principles, integrating small-area heaters that heat small regions to near-boiling (for pathogen lysis and deactivation) and large-area heaters (for amplification) on the same PCB. We show that both classes of heaters have high intra-board and inter-device reproducibility despite only heating a NAAT cartridge from below. We validated the small-area heaters by lysing methicillin-resistant Staphylococcus aureus (MRSA) cells and the large-area heaters by performing two types of isothermal NAATs (isothermal strand displacement amplification (iSDA) and loop-mediated isothermal amplification (LAMP)). These results demonstrate the merit of integrating NAAT heaters and control electronics onto a single printed circuit board and are a step toward translating NAATs to the home. [ABSTRACT FROM AUTHOR]