학술논문

Evaluating Downlink MU-MIMO: Laboratory Experimentation and Results
Document Type
Periodical
Source
IEEE Vehicular Technology Magazine IEEE Veh. Technol. Mag. Vehicular Technology Magazine, IEEE. 7(4):46-54 Dec, 2012
Subject
Transportation
Aerospace
Computing and Processing
Robotics and Control Systems
Downlink
MIMO
Radio communication
Interfaces
Next generation networking
Mobile communication
Long Term Evolution
OFDM
Frequency conversion
Laboratories
Language
ISSN
1556-6072
1556-6080
Abstract
The Third Generation Partnership Project (3GPP) finalized the radio interface specifications for the next generation mobile communication system, Long Term Evolution (LTE), as Release 8 [1], [2]. LTE provides full IP packet-based radio access with low latency and adopts orthogonal frequency division multiple access (OFDMA) and single-carrier frequency division multiple access (SC-FDMA) as multiple access schemes in the downlink and uplink, respectively. In Japan, the NTT DOCOMO launched a commercial LTE service in December 2010 under the new service brand Xi (crossy) [3]. Meanwhile, in 3GPP standardization, there have been efforts toward establishing an enhanced LTE radio interface, LTEAdvanced (LTE Release 10 and beyond), and specifications for LTE Release 10 were finalized [4], [5]. In LTE-Advanced, it is necessary to support a wider bandwidth than that in LTE Release 8, i.e., 20 MHz, to satisfy the high level requirements corresponding to the target peak data rate of greater than 1 Gb/s. To this end, LTEAdvanced supports carrier aggregation (CA) up to 100 MHz by aggregating multiple component carriers (CCs) with backward compatibility to LTE Release 8. In addition, to satisfy the requirements for further improvement in terms of spectrum efficiency, enhanced multiple-input multiple-output (MIMO) techniques such as higher-order MIMO multiplexing and multiuser (MU)-MIMO are supported.