학술논문
Low-Noise Operational Amplifier Using Dual-Path Dual-Chopper Fill-in Technique
Document Type
Periodical
Source
IEEE Sensors Journal IEEE Sensors J. Sensors Journal, IEEE. 24(8):12550-12559 Apr, 2024
Subject
Language
ISSN
1530-437X
1558-1748
2379-9153
1558-1748
2379-9153
Abstract
A low-noise operational amplifier is the key building block of the high-precision sensor interface circuit. Conventional continuous-time operational amplifiers suffer from low-frequency noise components, and multipath amplifiers are a good solution to achieve both low-noise and wide bandwidth. This article presents a low-noise multipath chopper-stabilized operational amplifier with a dual-path dual-chopper fill-in technique. The low-frequency path (LFP) of the multipath amplifier is implemented using two dual-path chopper amplifiers. The noise correlation between the dual path chopper amplifiers can reduce the input-referred noise level. The dual chopper amplifiers are driven by two quadrature chopper clocks. The glitch-free durations of the chopper amplifier outputs are combined using the fill-in technique to reduce the unwanted switching artifacts including glitches and intermodulation distortions (IMDs). The circuit was fabricated using a 180 nm complementary metal-oxide-semiconductor (CMOS) process and draws $46.5 ~\mu \text{A}$ at a supply voltage of 1.8 V. The input-referred noise and input-referred offset are 6.42 nV/ $\surd $ Hz and $10.5 ~\mu \text{V}$ , respectively. The gain-bandwidth product is 874 kHz. The power supply rejection ratios (PSRR+ and PSRR−) and common mode rejection ratio (CMRR) are 118, 111, and 90 dB, respectively. The chopper clock is 19 kHz. The IMD tones with 75 kHz input are below −61 dB.