부산대학교 도서관

This paper presents a millimeter-wave (mm-wave) phase-locked loop (PLL), with an output frequency centered at 54.65 GHz. It demonstrates a mode-switching architecture that considerably improves the lock time, by seamlessly switching between a low-noise mode and a fast-locking mode that is only used during settling. The improvement is used to counteract the increased lock-time caused by cycle-slips that results from using a high reference frequency of 2280 MHz, which is several hundred times the loop bandwidth. Such a reference frequency alleviates the noise requirements on the PLL and is readily available in 5G systems, from the radio frequency PLL. The mm-wave PLL is implemented in a low-power 28-nm fully depleted silicon-on-insulator CMOS process, and its active area is just 0.19 mm 2 . The PLL also features a novel double injection-locked divide-by-3 circuit and a charge-pump mismatch compensation scheme, resulting in state-of-the-art power consumption, and jitter performance in the low-noise mode. In this mode, the in-band phase noise is between −93 and −96 dBc/Hz across the tuning range, and the integrated jitter is between 176 and 212 fs. The total power consumption of the mm-wave PLL is only 10.1 mW, resulting in a best-case PLL figure-of-merit (FOM) of −245 dB. The lock time in low-noise mode is up to $12~\mu \text{s}$ , which is improved to $3~\mu \text{s}$ by switching to the fast-locking mode, at the temporary expense of a power consumption increase to 15.1 mW, an integrated jitter increase to between 245 and 433 fs, and an FOM increase to between −235 and −240 dB.