부산대학교 도서관

The high energy neutron generation facilities worldwide uses the Li(p,n) system for production of the quasi mono-energetic neutrons from epithermal to few hundreds of MeV. Among the facilities either self-standing thick Li target or Li foil supported on a target assembly is used. In case of a supported Li target, either low or high mass supporting substrates like Al, C, Au, Ta etc. can be used. However, the neutron emission from the supporting substrate can interfere with the Li(p,n) reaction neutrons. In the present study neutron yields from a thin natural Li target supported on the thick natural Ta (high Z) and C (low Z) targets were measured at incident proton energies between 8-20 MeV. The proton irradiation of targets were performed at the Pelletron accelerator Facility, Mumbai and the emitted neutrons were measures at both forward (0°) and lateral (90°) directions with respect to the incident beam. The neutron yield was estimated using the CR-39 detectors and dual scintillator based active neutron spectrometer. A neutron dose equivalent (NDE) meter was also used to measure the neutron ambient dose equivalent at the measurement point. Experimentally measured neutron yields and ambient neutron dose equivalent estimates indicated higher Li(p,n) neutron yield with carbon as the supporting substrate. This is due to fewer self-emissions from natC compared to natTa target. Carbon supporting substrate also ensures improved spectral features of the Li(p,n) emission neutrons and lesser neutron fluence around the source location. This ensures efficient implementation of radiation protection practices with carbon target due to lower neutron fluence around the source compared to tantalum target. Carbon is a favorable supporting substrate compared to high Z-metal targets like Ta for emission neutron studies on Li target at proton energies between 8-20 MeV. [ABSTRACT FROM AUTHOR]